SEARCH
Enter keywords, product name, or question
- ALWAYS disconnect the tool from power before starting.
- You will need a PH3 Screwdriver, a 10-13mm Allen key & a Rubber Mallet.
- To start, locate the internal screw within the centre of the Drill chuck.
- Then insert the PH3 Screwdriver into the chuck & unscrew CLOCKWISE (Reverse thread)
- Unscrew the centre screw and remove. Do not discard.
- Insert the Allen key into the drill chuck & tighten.
- You will need to apply strong force to the Allen key ANTI-CLOCKWISE to loosen the chuck
- You may wish to use a mallet and secure the drill to apply enough force.
- Loosen by hand ANTI-CLOCKWISE and remove the chuck
